How do you put a bobbin back in?

How does the bobbin holder go in?

Raise the needle to its highest position by rotating the hand wheel toward you.

  1. Remove the bobbin cover plate by pushing the release button to the right. …
  2. Insert the bobbin making sure the bobbin rotates counterclockwise when you pull the thread. …
  3. Pull the thread through the slot (A) and then to the left.

Why is my bottom thread bunching up?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

Why is my bobbin thread not catching?

Check the upper thread. – Check to see if your upper tension is too tight. … – Your thread could be caught on something between the needle and your spool of thread if so, your thread will be too tight for the needle to pick up the bobbin thread. – Make sure that the upper thread is threaded properly.

How do you fix a bobbin that does not wind?

If your bobbin does not wind quickly and smoothly when you press on your foot pedal, your bobbin winder might not be fully engaged. This can cause uneven winding. Make sure you push your bobbin pin all the way over or loosen your bobbin wheel completely to engage your bobbin winding mechanism.

THIS IS AMAZING:  Question: What tension should an Overlocker be?

Are bobbin cases universal?

While they are technically interchangeable in most cases, it is recommended that you only use one or the other. The weight of the bobbin can affect your tension and the way the thread feeds. These are the most common bobbins, as they are used with removable and inset bobbin cases.

Why is my bobbin jumping?

There could be several reasons why the bobbin is jumping in the bobbin case. … The thread was not wound properly on the bobbin. Wind the bobbin thread properly.

What holds the bobbin while it winds?

Bobbin spindle– holds the bobbin while it winds. Bobbin winder tension- provides tension on the thread when the bobbin winds.