Probable Causes: – Top or bobbin thread is not set correctly. – Make sure that the bobbin was threaded properly in the shuttle race. …
You should see a small screw on the flat/closed side of the bobbin case. Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension.
The tension could be too tight or too loose. Set the tension to the basic thread tension setting or adjust the tension manually. The combination of the needle size, thread size and fabric is incorrect. Be sure to use the correct size needle and thread for the type of fabric that you are sewing.
Why does my bobbin thread show on top?
If the bobbin thread is on top, that means the top thread is pulling more, or, has more tension. That means either the top thread is too tight or the bobbin thread is too loose.
If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.
Why does my sewing machine keep getting jammed?
If your bobbin is threaded wrongly, it could cause jamming issues to your sewing machine. Your bobbin thread won’t move properly if there are knots or if the bobbin isn’t properly wound. Check to see if the threading on your bobbin is all tangled, and fix it if you can.
Why is my machine sewing gathers?
Tension pucker is caused while sewing with too much tension, thereby causing a stretch in the thread. After sewing, the thread relaxes. As it attempts to recover its original length, it gathers up the seam, causing the pucker, which cannot be immediately seen; and may be noticeable at a later stage.