What is C4 error code?
the C4 code is a freezer compartment defrosting sensor error.
What should the tension be on a Singer sewing machine?
The target figure should be around 30 to 40g. (1-1/4 to 1-1/2 oz) but it does not have to be too precise. However most people don’t have a spring balance handy, so alternatively you can tie a weight of the correct amount onto the thread and then jerk the bobbin gently upwards.
What does C2 mean on a Singer sewing machine?
The C2 error message will appear if the Buttonhole Lever is not full engaged. When pulling it down into position, make sure it is all the way down. When finished sewing buttonholes, make sure it is raised all the way up before doing regular sewing. Lynn – SINGER Sewing Company.
What is C4 error in washing machine?
The 4E (4C) error code indicates that the washing machine has detected a problem with the water supply. The most common reason for this error is a blocked or kinked water supply hose. Try the below troubleshooting steps to resolve.
What does C4 mean in washing machine?
Why is the washing machine noisy during spinning process and indicates C4 error code sometimes? This is because the clothes are not balanced inside the washing tub. When this occurs, please pause the spinning operation, open the lid and do some adjustment on the clothes.
How do I reset my singer stylist?
NOTE: To set the needle at the highest position, turn the hand wheel TOWARDS you, until the needle moves to the highest position. Finally, push the reverse button a couple of times, this will reset the machine.
What does E5 mean on a Brother sewing machine?
You receive the error message E5 when the start/stop button was pressed while the foot controller was connected. 1. Disconnect the foot controller, and then press the Start/Stop button. – Otherwise, operate the machine by using the foot controller.
Why is my thread bunching underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
The buttonhole lever is positioned behind the bracket on the buttonhole foot. Gently hold the end of the upper thread in your left hand, and then start sewing. Once sewing is completed, the machine automatically sews reinforcement stitches, then stops.