Why is my sewing machine looping underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
How do I know if my bobbin tension is correct?
The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.
What width should my sewing machine be on?
A straight stitch has no width so it makes sense to set the dial at “0”. However, each machine varies so you will want to set the Stitch Width dial at the position where the needle is centered over the stitch plate. This will give you the most accurate seam allowance.
How do I stop my sewing machine from bunching up?
A good cleaning may solve your bunching woes (check your manual for guidelines on cleaning and maintenance; your machine may also need to be oiled). To prevent stitch glitches, be sure to frequently dust underneath the throat plate and along the thread path, and to periodically clean and oil your machine.
How do I stop my sewing machine from looping?
Looped stitches are usually caused by improper tension. If the loop is on the upper side, it may be corrected by loosening the top tension or by tightening the lower tension. If the loop is on the under side, it is usually best corrected by adjusting the upper tension.
Why is my top thread so tight?
If the bobbin thread was incorrectly threaded, the upper thread may be too tight. … If the upper thread was incorrectly threaded, the upper thread may be too loose. 4. To increase the upper tension – increase the tension setting or turn the knob to the right.
What tension should I use for cotton?
Cotton requires a moderate tension setting, usually between three and four.